The Weekend Project: Borax Crystal Snowflake Ornaments
This week’s project is a mix of craft and kitchen-table chemistry. You twist a pipe cleaner into a snowflake and hang it in a jar of very hot borax solution. As the solution cools overnight, crystals build up on the pipe cleaner. They sparkle like real snow crystals, but won’t melt.
You only need a few minutes of hands-on time, but the crystals need to sit undisturbed for several hours, and overnight is better. If you start on Friday evening, November 20, you can hang the ornaments on Saturday.
What You Need
- Pipe cleaners. White works well, and so do blue or glittery ones.
- A wide-mouth glass jar that can safely hold boiling water. It has to be big enough for the finished snowflake to fit through the opening.
- Powdered borax, which is found in the laundry detergent section
- Boiling water, string, a pencil or craft stick, scissors and a tablespoon
- Food coloring and ribbon (optional)
Use 3 to 4 tablespoons of borax for every cup of water. For easy measuring, 16 tablespoons equals 1 cup. As an example of scale, one batch for three snowflakes used 6 cups of water and 22 tablespoons of borax.
Steps for Borax Snowflakes
- With scissors, cut a pipe cleaner into three equal sections. Twist the pieces together at the center to make a six-sided snowflake. Be careful when you bend the wire, because the ends are sharp.
- Tie one end of a short string to the snowflake and the other end to a pencil. Lay the pencil across the jar to check the fit. The snowflake should hang freely without touching the bottom or sides.
- Take the snowflake out. Boil the water in a separate pot and pour it into the jar until the jar is almost full.
- Stir in the borax one tablespoon at a time, letting each spoonful dissolve before adding the next. It’s fine if some powder settles at the bottom.
- If you want color, add food coloring now. One drop of blue gives you blue snowflakes.
- Lower the snowflake back in. Rest the pencil on the rim so the snowflake is completely covered with liquid.
- Put the jar somewhere it won’t be bumped. Keep the temperature steady, since temperature fluctuations can also affect crystal growth.
- After 12 to 24 hours, lift the snowflake out and let it dry on a paper towel. Tie a ribbon to one arm for hanging.
Timing and Why It Works
You’ll usually see crystals forming within a couple of hours, but leave the jar overnight for the best results. After about 24 hours there is little more growth. To get a thicker coat, reheat the solution and put the snowflake back in for another night.
The heat is what makes this work. Hot water dissolves much more borax than cold water does. As the water cools, it can no longer hold all of that borax, and the extra comes out as crystals on the pipe cleaner. Hot tap water may not be hot enough, which can mean smaller or fewer crystals. Salt and sugar form cube-shaped crystals, but borax forms six-sided structures.
Safety With Borax
Borax is sodium tetraborate, a natural mineral salt commonly used as a laundry booster or cleaner. Borax dust can be harmful if swallowed, inhaled, or gets into your eyes. For that reason, boil the water in a separate pot, pour it into the jar, and then add the borax.
Do not let children swallow borax. If someone does, call a poison control center right away. Borax is slightly caustic, so an adult should measure it and add it to the water. Children can help stir. An adult should also handle all the boiling water.
Ways to Adapt the Project
- Other shapes: Pipe cleaners can also be bent into hearts, stars or small balls.
- More at once: If the jar is wide enough, hang two shapes from one stick, or set up several jars side by side.
- Cleanup: Hot water dissolves the crystals left on the jar, so you can reuse it.
- Storage: Moisture in the air can leave a white crust on the crystals. To slow this down, wrap each snowflake in tissue paper or a paper towel and store it in a plastic bag with a silica gel packet.
FAQ
– Do I really need boiling water?
Boiling water gives the best results. Water that is very hot but not boiling can work as long as all the borax dissolves. Lukewarm tap water usually gives smaller, sparser crystals.
– Can the ornaments be used again next year?
Yes, they can last from one year to the next. Store them wrapped and dry, with a silica gel packet, to keep the white crust from forming.
Sources
- Borax Crystal Ornaments – Steve Spangler — stevespangler.com
- Make Borax Crystal Snowflakes — sciencenotes.org
- Borax Crystal Snowflake – Imagination Station — imaginationstationtoledo.org
